[SlimDevices: Duet] Squeezebox Controller stuck at logictech screen

[queball56]

The firmware update failed on my squeezebox controller. Now the
controller is stuck at the logitech screen. I tried the factory reset (
holding add while powering on the remote). That didn't resolve the
issue. I believe the controller is now bricked. Does anyone have a
solution for this issue?

[cmanley542]

Mine freezes on the Logitech logo almost every time I turn it off (which
I now do very rarely).

I usually have to take the battery out and replace it 10-15 times
before it will boot past the logo into the main menu.

I've asked support about this issue twice, but they don't seem to think
it's an issue, they say "Did you try a factory reset?" Yes, I did, and
now it's frozen on the Logitech logo, this issue apparently is not
alarming to them.

[queball56]

I haven't tried the sd firmware update for the fact that the
instructions say you have to invoke the update via the menu on the
controller. I can't get to the menu, so I didn't think that was a
viable option. I have a ticket open with squeeze support. Once they
respond I will post an update.

[Gadgety]

It's happened to me a couple of times yesterday. That was the first time
in one year. I just took out the battery, reinserted it, and then it's
been functioning fine. YMMV.
--
Gadgety

System 1: SB Duet --> Tact RCS 2.2x room correction pre-amp &
cross-over
--> Tact 2150 --> Tact W210s (bass)
--> Sanders ESL Amp --> Custom made 84 inch tall flat ESLs (mid/tweet)


System 2: SB Duet --> Tact Millennium Mk II --> Martin Logan CLSIIa
------------------------------------------------------------------------
Gadgety's Profile: http://forums.slimdevices.com/member.php?userid=27364
View this thread: http://forums.slimdevices.com/showthread.php?t=62045

[Rik]

I have the same problem, see my earlier posting
http://forums.slimdevices.com/showthread.php?t=58107. I have talked to
support for a while now but we have not been able to solve this yet. My
suggestion is to contact support.

It might be useful for them to have a log from the booting process. To
do so, first make a directory called "log" in the root directory of a
SD card, then insert it in the controller (remove battery, then you
have access to the SD card slot).

Best regards,


Rik